Gearench ZB1260U PETOL Hydraulic Pump Bench Bedienungsanleitung

Petol Friction Breakout Unit ZB1260U Operating Manual Gearench P.O. Box 192 4450 Highway 6 South Clifton, Texas 76634 Phon

10 Installation Location The Petol Friction Breakout Unit should be located in an area with adequate room to work the tools. The unit should be loc

11 Operation The hydraulic pressure gauge is used to indicate the current system pressure in psi. See the torque-pressure conversion chart below.

12 Loading To load the tool in the unit set the tool into the vise or benchrench as needed. Adjust the vee-saddle or pump support to support the to

Safe Operating Area For safe operation, it is recommended that the operator and other personnel not stand in the areas shown in the figure below duri

14 Parts List The following drawings, diagrams, and parts lists describe all parts, which may be needed as replacement items. Where appropriate, st

Final Assembly Parts List 15

16 Final Assembly Item Qty Part Number Description Make/Model Notes 1 1 ZB1260 Bench assembly 2 1 ZB1260U-1 Rail 3 1 UHCY-ZB Cylind

Cylinder Assembly 17

18 Cylinder Assembly Item Qty. Part Number Description Make/Model Notes 1 1 UHCY-ZB-EB Eye bracket 2 1 UHCY-ZB-C Cylinder Vickers/Aeroquip

2 Table of Contents Petol ZB1260U Unit Description ...

3 Petol ZB1260U Unit Description The ZB1260U Petol Friction Breakout Unit was designed for making up and breaking out downhole pumps and specialty d

4 Warranty What Is Covered Gearench tools are expressly warranted to you, the purchaser, to be free of defects in material and workmanship. How Long

5 Forum Selection Clause Any dispute arising out of the sale and/or use of the GEARENCH tool that is the subject of this limited warranty shall be pr

6 Safe Practices and Procedures Responsibility "It is the responsibility of the employer to train the employee in the proper selection and usag

7 Safe Practices (Source: The National Safety Council) Failure to observe one or more of the following five safe practices accounts for most hand an

8 Safety Sources and Publications In the interest of Safety the following sources of Safety information is furnished: The Hand Tools Institute (HTI

9 Safety Precautions 1. Always wear safety goggles to protect eyes. 2. Select the right tool for the job. 3. Keep tools in good condition.